This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
maftcalibrationbywbo2 [2010/05/13 10:41] dmertz |
maftcalibrationbywbo2 [2010/05/13 10:45] dmertz |
||
---|---|---|---|
Line 55: | Line 55: | ||
Example: If the fuel trim is at a constant +7%, add +7% to the 250 Hz slider in the airflow table. Repeat until you are happy. | Example: If the fuel trim is at a constant +7%, add +7% to the 250 Hz slider in the airflow table. Repeat until you are happy. | ||
+ | |||
Line 76: | Line 77: | ||
| Adjustment | +17%| +25%| +13%| +4%| +3%| -1%| | | Adjustment | +17%| +25%| +13%| +4%| +3%| -1%| | ||
- | **Note:** The following calculation method provides a crude approximation of the needed adjustment and depends on the estimated and measured A/F ratio values being somewhere near 10:1. | + | **Note:** The following calculation method provides a crude approximation of the needed adjustment and depends on the estimated and measured A/F ratio values being somewhere near 10:1. Use ECMLink's correctly calculated WBFactor value instead. |
A simple formula for calculating this is:<code> | A simple formula for calculating this is:<code> |