nonepromprocess2g
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
nonepromprocess2g [2016/09/23 15:01] twdorris [Finished Product] |
nonepromprocess2g [2024/03/15 11:16] (current) |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| - | {{:noneprom2gbefore.jpg?direct&296x236 }} | + | |{{:noneprom2gbefore.jpg?direct&296x236 }} | |
| ===== CPU Removed ===== | ===== CPU Removed ===== | ||
| Line 22: | Line 22: | ||
| - | {{:noneprom2gafter.jpg?direct&267x190 }} | + | |{{:noneprom2gafter.jpg?nolink&267x190 }} | |
| ===== Adapter Plug ===== | ===== Adapter Plug ===== | ||
| - | After the CPU is removed, we have to install an adapter plug in its place (left picture). We do not make this plug, but we do pay dearly for it! Note the careful solder work involved on those castellations (side pads) on the adapter board. | + | After the CPU is removed, we have to install an adapter plug in its place (left picture). We do not make this plug, but we do pay dearly for it! Note the careful solder work involved on those castellations (side pads) on the adapter board. |
| Line 33: | Line 33: | ||
| - | {{:qfp100base.jpg?direct&289x212 }}{{:qfp100mate.jpg?nolink&289x212}} | + | |{{:qfp100base.jpg?nolink&289x212 }} |{{:qfp100mate.jpg?nolink&289x212}} | |
| ===== Finished Product ===== | ===== Finished Product ===== | ||
| - | The final step is to snap our specially designed conversion board into place. The following picture shows the finished result (click to enlarge). Note the machined mounting bar and machined spacers used to secure the board in place using the mounting points provided in the factory ECU case bottom. There is a LOT of manual, custom work done to produce these boards. | + | The final step is to snap our specially designed conversion board into place. The following picture shows the finished result (click to enlarge). Note the machined mounting bar and machined spacers used to secure the board in place using the mounting points provided in the factory ECU case bottom. There is a LOT of manual, custom work done to produce these boards. |
| - | {{:2gnoneprom2.jpg?direct&281x212 }} | + | |{{:2gnoneprom2.jpg?nolink&281x212 }} | |
nonepromprocess2g.1474657315.txt.gz ยท Last modified: 2016/09/23 15:01 by twdorris
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
